Front speakers sound. Can’t hear main sound?
This is the front speaker amplifier. It is located in the inner side of the simulator, near the power strip. Please make sure it is ON and sound cable is connected to the PC and to the amplifier.
The cable type is RCA - 3.5mm
Click on a speaker sign in the system tray and make sure it is at least 70%.
Right mouse click on Sound Icon on Windows start panel -> Sound or, open Sound settings via Control Panel (Win+R, type Control and navigate to the speaker icon)
Make sure the setting below are applied:
Right mouse click on the green socket and assign it as the Front speaker out:
When this is done, test front speakers in the main menu of the Realtek Manager again. If there is still no sound, then refer to the visual scheme above this section and check the whole line from the PC till the front speakers.
Can’t find Realtek Sound Manager**?**
Hit Win+R and type dxdiag then open the first tab and there you will see the motherboard model name.
Use the name in the search line on the Internet and open the official vendor website, proceed to the Support section and find the Realter driver there. You may need to reboot 2 times.
The vibration signal passes a route via several wires through an amplifier to reach the vibration unit under the platform. Below is a scheme:
Normally, it is enough to test vibration in the Realtek manager.
Hit the rear left speaker icon and the platform must vibrate shortly but audible. Below is a scheme of the sound manager which is set up as a 7.1 Speaker system. This is where you can test the rear left speaker to check vibration.